Buy the Lenco Marine 102 Actuator on http://www.boatersworld.com Print This PagePrint This Page
Lenco Marine 102 Actuator image
 
(based on 2 ratings)
Brand: Lenco Marine
Located in: trim tabs
102 Actuator

Used with Troll'n Tab Kits prior to 2000
5/16" (.79 cm) mounting hardware
Stroke: 4-1/4" (10.8 cm)
Length overall: 14" (35.56 cm)
Length pin to pin: 13" (32.87 cm)
Diameter (upper housing): 2-1/2" (6.35 cm)
Mounting hardware: 5/16" (.79 cm) or Delrin Pin (Part #15087-001)

Part # (Superceded #)
# 15059-001 (102-2) 12 Volt w/6' (1.83m) leads with Deutsch connectors (replacement length)

  • Top cap gland seal sheaths the actuator cable outer jacket as well as both internal conductors for maximum waterproofing
  • Corrosion proof Vandar mounts
  • Stainless steel ram won't flex, even under extreme loads
  • Double O-ring for maximum protection
  • Ballscrew rotates freely on 12 ball bearings at both ends of its stroke so there's no need for complicated limit switches and clutches
  • Self-locking ballscrew locks into position and will not drift
  • Precision molded, powdered metal, high alloy gears provide high accuracy, high wear resistance, and high strength for long life
  • Tough, high-torque motor easily transfers 750 lbs
  • High-impact, ultraviolet resistant nylon 66, 50% glass fiber reinforced thermoplastic housing
  • Corrosion proof Vandar cap and mount, stands up to severe loads
Review Snapshot®
Avg. Customer Rating:
 
5 stars
(based on 2 reviews)
 
Replacement actuator works fine
By PartsmanVerified Purchaser from Texarkana, Tx. on 8/24/2008
Pros:
Easy to Use
Best Uses:
Engine
Describe Yourself:
Recreational
Bottom Line:
Yes, I would recommend this to a friend

Comments about Lenco Marine Lenco Marine 102 Actuator:

Good replacement of the original actuator. Works very well and easily installed.

[1 of 1 customers found this review helpful]

 
Very Good Product
By captjeffgVerified Purchaser from Galveston Texas on 8/18/2008
Pros:
Durable, High Quality
Bottom Line:
Yes, I would recommend this to a friend

Comments about Lenco Marine Lenco Marine 102 Actuator:

This actuator is Just what my boat needed. I replaced my old Bennet actuators with Lenco 101 actuators. The 101's didn't have enough stroke to bury the bow in heavy seas. To compromise I put a Delrin block between the actuator and the tap plate. I was now able to bury the bow but I wasn't able to fully retract my taps in calm water. My fuel economy was hurting with the extra drag. I installed these 202's and problems are all solved. With over 4 inches of stroke I can bury the bow and fully retract the tabs when I need to.
Thanks Lenco!!

Powered by PowerReviews
Copyright © 2011 BoatersWorld.com All Rights Reserved. Do not republish contents.